R-Forge > GitHub?
Hi, Ott et al.: ????? What's the best way to get "Travis CI" to build and test the two packages, Ecdat and Ecfun, that have long been combined in the Ecdat project? ????? Following Ott's advice and studying studying Wickham's "R Packages" (http://r-pkgs.had.co.nz/), I was able to configure RStudio so it would sync using git with "GitHub.com/sbgraves237/Ecdat".? However, when I tried to configure "Travis CI", it said, "No DESCRIPTION file found, user must supply their own install and script steps". ??? ? Earlier in this thread, I think someone suggested I make the Ecdat and Ecfun packages separate projects on GitHub (though I can't find that suggestion now).? This would not be an issue if it were all local without version control.? With RStudio managing my interface with GitHub, it now seems quite tricky. ????? Suggestions? ????? Thanks again to all who have offered suggestions so far.? This migration from R-Forge to GitHub seems complete except for the automatic tests provided via "Travis CI". ????? Spencer
On 2019-06-28 22:25, Ott Toomet wrote:
Apparently your username/password are wrong.? Can you clone/push from
other repos?
You do not need authorization when cloning a public repo, so even
incorrect credentials may work (haven't tested this though).? But for
push you have to have that in order.
I suggest you create ssh keys, upload those to GH, and use ssh
authorization instead of https.
Cheers,
Ott
On Fri, Jun 28, 2019 at 8:18 PM Spencer Graves
<spencer.graves at prodsyse.com <mailto:spencer.graves at prodsyse.com>> wrote:
Thanks to Duncan, Henrik and Henrik, Brian, and G?bor:
?????? I created a local copy of the new GitHub version using the
following:
git clone
https://sbgraves237:mypassword at github.com/sbgraves237/Ecdat.git
?????? That worked in the sense that I got a local copy. However,
after
I rolled the version number and did "git commit" on the DESCRIPTION
files, my "git push" command generated the following:
remote: Invalid username or password.
fatal: Authentication failed for
'https://sbgraves237:mypassword at github.com/sbgraves237/Ecdat.git/'
?????? What am I missing?? [Note:? I used my actual GitHub
password in
place of "mypassword" here, and this "Authentication failed" message
reported the GitHub password I used here.]
?????? Thanks,
?????? Spencer
p.s.? I'm doing this under macOS Mojave 10.14.5.? Also,? I added
".onAttach" functions to the R-Forge versions as Brian G. Peterson
suggested.? That seemed to work fine.
On 2019-06-28 07:13, Duncan Murdoch wrote:
> On 28/06/2019 6:26 a.m., G?bor Cs?rdi wrote:
>
>> Instead, you can do as Duncan suggested, and put a README in your
>> R-Forge
>> repository, that points to *your* GitHub repositor(y/ies). Then the
>> https://github.com/rforge/ecdat read only mirror will pick this up
>> and will
>> point there as well.
>
> Just for the record:? that was Henrik Singmann's suggestion, I just
> agreed with it.
>
> Duncan Murdoch
>
? ? ? ? [[alternative HTML version deleted]]
______________________________________________
R-devel at r-project.org <mailto:R-devel at r-project.org> mailing list
https://stat.ethz.ch/mailman/listinfo/r-devel