binomial GLM quasi separation

lincoln<miseno77<at>  hotmail.com>  writes:

Hi all,

I have run a (glm) analysis where the dependent variable is the gender
(family=binomial) and the predictors are percentages.
I get a warning saying "fitted probabilities numerically 0 or 1 occurred"
that is indicating that quasi-separation or separation is occurring.
This makes sense given that one of these predictors have a very influential
effect that is depending on a specific threshold separating these effects,
in other words in my analysis one of these variables predicts males about
the 80% of times when its values are less or equal to zero and females about
the 80% when its values are greater than zero.
I have been looking at other posts about this but I haven?t understood how I
should act when the separation (or quasi separation) is not a statistical
artifact but it is something real.
As suggested in
http://r.789695.n4.nabble.com/
  OT-quasi-separation-in-a-logistic-GLM-td875726.html#a3850331
http://r.789695.n4.nabble.com/
  OT-quasi-separation-in-a-logistic-GLM-td875726.html#a3850331

   [warning, broke URLs to make gmane happy]

(the last post is mine) I tried to use brglm procedure that uses a penalized
maximum likelihood but it made no difference.

   I'm not sure what's going on here, and I don't know why brglm()
shouldn't work ... from a squint at your Nabble post (I can't
really see the figure very well), I agree that
the hcp profile is funky, but I wouldn't immediately conclude that
the profile is bad -- in particular, it seems that the x-axis range
is -45 to -15, rather than something like (-600,-300) as I would expect
from the estimated parameter (ca. -400) and standard error (ca. 60).
I would start by setting which=3 (to confine your attention to the
hcp parameter) and messing around with the gridsize, stepsize, stdn
parameters in profileModel to see what's going on.

  If that doesn't work you might have to post data, or a subset of
data, in order to get any more help ...