Rcmdr on Debian
<arv at ono.com> writes:
Hi, I've been able to run Rcmdr on Debian-Woody without too much problems, just to load first the tcltk and car libraries. The issue is that after leaving R I'm not able to see at the prompt any character like 'ls', but the unix instructions are executed, don't know why the visualization of the unix commands is cancelled.
This can happen even without the tcltk stuff. Not quite sure why (most likely, it is readline-related), but the way out is to type "stty sane" at the shell prompt.
O__ ---- Peter Dalgaard Blegdamsvej 3 c/ /'_ --- Dept. of Biostatistics 2200 Cph. N (*) \(*) -- University of Copenhagen Denmark Ph: (+45) 35327918 ~~~~~~~~~~ - (p.dalgaard at biostat.ku.dk) FAX: (+45) 35327907