Issues with TMPDIR/TEMP/TMP? Failure of R CMD check under Windows 7
On Sun, Feb 24, 2013 at 4:00 PM, Ulrike Gr?mping
<groemping at bht-berlin.de> wrote:
Dear helpeRs, on my Windows 7 laptop, I have problems getting R CMD check to work. I believe it did work completely before, but I am not sure. Yesterday it almost worked, except for the tests: These were aborted because of a complaint that the temporary directory wasn't available. I played with windows environment variables for the temporary directory, but that didn't solve it. Apparently I did something that made things worse: Today, R CMD check completely refuses to work, with the error message "Fatal error: creation of tmpfile failed -- set TMPDIR suitably?" This is the same for current R and R-devel. Changes to the TEMP or TMP environment variable don't influence this behavior. The path: C:\Rtools;C:\Program Files\Dell\DW WLAN Card;C:\Program Files\R\R-2.15.2\bin;C:\Windows\system32;C:\Windows;C:\Windows\System32\Wbem;C:\Windows\System32\WindowsPowerShell\v1.0\;C:\Program Files\Intel\OpenCL SDK\2.0\bin\x86;C:\Program Files\WIDCOMM\Bluetooth Software\;C:\Program Files\Calibre2\;C:\Program Files\MiKTeX 2.9\miktex\bin\;C:\Program Files\TortoiseSVN\bin Any ideas what I can do to fix this? Perhaps also relevant: I run R CMD check from a DOS window that is opened with administrator rights.
1. Remove the paths to Rtools and to R in PATH since they don't look correct. 2. Enter this from the Windows cmd line: SET U SET T and it should show that TMP is set to %userprofile%\AppData\Local\Temp and that TEMP is set to the same thing and TMPDIR is not listed. If not change them so that it so reads. 3. Once you have done all the above then place this file anywhere on your path https://batchfiles.googlecode.com/svn/trunk/R.bat The following will find R using the registry or if its not there it will look in the usual places and then run it so you can then try: R.bat CMD ...whatever... If that still does not work proceed to the following manual alternative: 4. If the above did not fix the problem download this file https://batchfiles.googlecode.com/svn/trunk/Rpathset.bat 5. edit the SET statements in it and then place it on your Windows path. 6. Now run it from the cmd line: Rpathset.bat and for the rest of that cmd line session your path should be set up correctly. Also you might want to read: https://batchfiles.googlecode.com/svn/trunk/batchfiles.md There is also a new discussion group just set up at https://groups.google.com/forum/?fromgroups#!forum/sqldf that is also being used for the batchfiles.