layout problem
I have a question about using the layout command within a function. I've written function that uses layout to create a figure from 2 plots. This works fine to create a figure. When I use par(mfrow = c(2,2)) to create multiple plots, it seems that the layout command resets the mfrow parmeter. Is there a way for me to avoid this problem?
As far as I understand that is not possible, since "`layout' divides the device up", not a part of the device. If you need to split your device again and again, you should package grid (or lattice, on a higher level); these allow to do so. However, these need different plot commands, i.e. plot() will not work with them HTH Thomas --- Thomas Hotz Research Associate in Medical Statistics University of Leicester United Kingdom Department of Epidemiology and Public Health 22-28 Princess Road West Leicester LE1 6TP Tel +44 116 252-5410 Fax +44 116 252-5423 Division of Medicine for the Elderly Department of Medicine The Glenfield Hospital Leicester LE3 9QP Tel +44 116 256-3643 Fax +44 116 232-2976