The following commands only draw two lines (blue and red ones) rather than three lines. plot(inData[[1]], inData[[2]], type='l', col="blue", ); lines(inData[[1]], mod.data$prepeak, col="green"); lines(inData[[1]], baseline, col="red"); But when I can draw three lines in different diagrams by using par(fraw=c(3,1)); plot(inData[[1]], inData[[2]], type='l', col="blue", ); plot(inData[[1]], mod.data$prepeak, type='l', col="green"); plot(inData[[1]], baseline, type='l', col="red"); What's wrong with the first three commands? Thanks,
question on plot
2 messages · Zhongming Yang, Dirk Eddelbuettel
On Tue, Dec 24, 2002 at 11:44:02AM -0500, Zhongming Yang wrote:
The following commands only draw two lines (blue and red ones) rather than three lines. plot(inData[[1]], inData[[2]], type='l', col="blue", ); lines(inData[[1]], mod.data$prepeak, col="green"); lines(inData[[1]], baseline, col="red"); But when I can draw three lines in different diagrams by using par(fraw=c(3,1)); plot(inData[[1]], inData[[2]], type='l', col="blue", ); plot(inData[[1]], mod.data$prepeak, type='l', col="green"); plot(inData[[1]], baseline, type='l', col="red"); What's wrong with the first three commands?