No, no, sorry: I did read and tried, but no success, again. Failed at exactly the same spot. However, at least I have rgl via apt-get. PM
Dirk Eddelbuettel wrote:
On 16 May 2009 at 14:04, Petar Milin wrote:
| Thanks, again! But can that be "messy" if I start installing via apt-get
| instead of using something like:
| install.packages() or
| R CMD INSTALL
I already told you that this what not so.
You also failed to read to the end of my mail for the second suggestion.
Dirk
| I installed via apt-get only r-base and r-base-dev, and everything else
| via R itself.
|
| Best,
| PM
|
| Dirk Eddelbuettel wrote:
| > On 16 May 2009 at 13:21, Petar Milin wrote:
| > | Thanks and sorry!
| > | I am using: R version 2.9.0 (2009-04-17), on Debian testing with
| > | apt-pinning for R base packages.
| >
| > Very well. So why don't you just do
| >
| > sudo apt-get install r-cran-rgl
| >
| > and use the pre-built binary.
| >
| > If you must rebuild from source, use
| >
| > sudo apt-get build-dep r-cran-rgl
| >
| > which gets you all required packages to then run install.packages("rgl") from
| > R.
| >
| > Hth, Dirk
| >