Matrix multiplication

On Mar 13, 2012, at 3:05 PM, Paul Gilbert wrote:

On 12-03-13 12:50 PM, Brian G. Peterson wrote:

On Tue, 2012-03-13 at 12:40 -0400, Paul Gilbert wrote:

Brian

Thanks for spelling this out for those of us that are a bit slow.
(Newbie questions below)

<... snip ...>

So, if your BLAS does multithreaded matrix multiplication, it will use
multiple threads 'implicitly', as Simon pointed out.

Is there an easy way to know if the R I am using has been compiled with
multi-thread BLAS support?

BLAS should be 'plug and play', as R is usually compiled to use a shared
object BLAS.  As such, installing the BLAS on your machine (and
appropriately configuring it) should 'just work' with te new BLAS when
you restart R.

Dirk et. al. wrote a paper, now a bit dated, that benchmarked some of
the BLAS libraries, that should have some additional details.

(I have a long history of getting things that should 'just work' to 'just not work'.) But I didn't really state my question very well. I'm really wondering about two related situations. How can I confirm after a change to underlying system that R is using the new configuration, and second, if I am  running benchmarks in R is there an easy way to record the underlying configuration that is being used.

You can check whether you're leveraging multiple cores simply via system.time:

m=matrix(rnorm(4e6),2000)
system.time(m %*% m)

    user  system elapsed
   6.860   0.020   0.584

The above is clearly using threaded BLAS (here I'm using ATLAS), because
the elapsed time is much smaller than the CPU time so it was computed in parallel.

In contrast this is what you get using single-threaded R BLAS on the same machine:

system.time(m %*% m)

    user  system elapsed
  10.480   0.020  10.505

It takes about 18x longer - this is a combination of the number of cores and the less optimized BLAS - and the elapsed time is greater or equal to the CPU time = single-threaded.

As for recording the underlying configuration - that is not really possible in general - you have toknow what you enabled/compiled. In case of a shared BLAS implementation 

Cheers,
Simon

Thanks again,
Paul

<...snip...>

Be aware that there can be unintended negative interactions between
implicit and explicit parallelization.  On cluster nodes I tend to
configure the BLAS to use only one thread to avoid resource contention
when all cores are doing explicit parallelization.

How do you do this? Does it need to be done when you are compiling R, or
can it be done on the fly while running R processes?

Some BLAS, like gotoblas, support an environment variable to change the
number of cores to be used.  This can be changed at run-time.  Others,
like the mkl, are always multithreaded.  Others, like ATLAS, can be
compiled in either single threaded or multi-threaded modes.

So, for me, on my cluster nodes, I use a single threaded BLAS, assuming
that *explicit* parallelization will be the primary driver of CPU load,
and not wanting to over-commit the processor when 12 calculations each
try to spawn 12 threads in the BLAS.  On other machines, I might use a
multithreaded BLAS like gotoblas so that I have some flexibility (though
apparently unlike Claudia, I rarely change it in practice).

Regards,

    - Brian